M-800 High Temperature Mould Release Paste Wax
OSKAR S M-800 is especially formulated for mouldings with high exoterm temperature or preheated moulds in polyester, epoxy, aluminium or nickel. lt contains a mixture of high quality synthetic waxes and lubricants, to provide an outstanding heat resistant mould protection and easy release of finished parts.
1. Apply wax liberally. Spread evenly in circular motion over ca. 70 - 80 cm in square. Make sure the wax completely covers the entire surface.
2. Immediately wipe off excess wax. As a slight haze appears, lightly, and without pressure, polish with a clean soft and dry cotton waste er using several pieces - frequently changing the pieces so fresh and dry areas are always used. Polish to a deep brillant gloss.
3. If the wax is allowed to dry before being polished, apply a second coat, wipe and polish immediately. Do not use a power buffer with M-800.
Flammable. Toxic to aquatic organisms, may cause long-term adverse effects in the aquatic environment.
Harmful: may cause lung damage if swallowed. Avoid contact with skin. Avoid release to the environment. Refer to special
instructions, Safety data sheets. If swallowed, do not induce vomiting: seek medical advice immediately and show container or label.
Store in a cool and dry place, protect from frost, 24 months
Refer to the Material Data Sheet.